Originale Hebebühnen Ersatzteile kaufen / gute Qualität

Our top products

lift pad, rubber pad, rubber plate for Hofmann Duolift Type GTE 2500 GT 2500 BT/BTE 2500 (140mm x 17mm)

1x lift pad, support plate, rubber pad, rubber plate for Hofmann...

12,38 EUR

incl. 19 % VAT excl. shipping costs

Plain bearing, DU-bushing, slide bearing for Hofmann Duolift type GTE 2500, MTF 3000 (for lower bearing flange)

1x Plain bearing, DU-bushing, slide bearing (for flange below)...

11,07 EUR

incl. 19 % VAT excl. shipping costs

spacer sleeve, increase for lift pad MWH Consul lift from 2004/2005 Type 2.5 / 2.7 / 2.8 / 3.2 / FH325 / H142 / H250 / 02266 37 (180mm increase)

1x spacer 180mm elevation for support plate quick plug system...

42,84 EUR

incl. 19 % VAT excl. shipping costs

original potentiometer, poti, relais for Zippo lift Type 1730 1731 1735 1751 (900 cm cable length, plastic)

potentiometer, poti, potis (900 cm cable length, plastic) for...

220,15 EUR

incl. 19 % VAT excl. shipping costs

Diving oiler, oil wipers new version for Romeico H225 H226 H227 H230 H231 H232 lift (Felt + Strap)

1x Diving oiler, oil wipers new version from serial number 3651...

54,74 EUR

incl. 19 % VAT excl. shipping costs

Washers + support disk between head bearing and radial bearing for Nussbaum lift Type SL SLE ATL (upper spindle bearing)

1x Washers + support disk between head bearing and radial bearing...

29,87 EUR

incl. 19 % VAT excl. shipping costs

Sliding block for Hofmann MTF 3000 Lift

1x Original plastic sliding block for Hofmann 2 post lift inter...

19,95 EUR

incl. 19 % VAT excl. shipping costs

safety nut for Ravaglioli RAV lift KP124N6 KPN / KPX versions (60mm long, right-hand thread, one motor or two motor)

1x safety nut for Ravaglioli RAV lift KPN / KPX versions...

130,90 EUR

incl. 19 % VAT excl. shipping costs

Keyway for pulley spindle drive Nussbaum SL SLE ATL SEL Lift

1x Parallel key for upper spindle drive nussbaum 2 post lift i.a....

8,99 EUR

incl. 19 % VAT excl. shipping costs

lifting nut and safety nut Set for Zippo lift Type 1730 1731 1735

1x original safety nut + lifting nut in Set for Zippo lift type...

364,97 EUR

incl. 19 % VAT excl. shipping costs

Phase converter, control switch for Zippo lift Type 1250 1226 1526 1232 1236

1x selector switch or phase converter (up & down switch) for...

188,36 EUR

incl. 19 % VAT excl. shipping costs

original potentiometer, poti, relay for zippo lift type 1730 1731 1735 1751 (short cable 60cm length)

1x Original potentiometer (short cable length 60cm) plastic /...

196,35 EUR

incl. 19 % VAT excl. shipping costs

Safety nut for Nussbaum Lift type SL 2.30 SL 2.32 SL 2.40 / SLE 2.30 SLE 2.32 SLE 2.40 (TR 45x6)

1x spindle nut - follower nut with latch - catch nut for Nussbaum...

238,00 EUR

incl. 19 % VAT excl. shipping costs

axial bearing for upper spindle bearing Nussbaum Lift Type ATL 2.25 2.30 2.32 / Eurolift 2500

Head bearing (ZKL/FAG/SKF axial bearing) for upper spindle...

31,18 EUR

incl. 19 % VAT excl. shipping costs

guide roller, supporting roller with socket for Romeico Atlantic 2 post lift 140mm and Atlantic old version

supporting roller, top roller, back-up roll, cam roller, roller...

105,91 EUR

incl. 19 % VAT excl. shipping costs

Lifting nut, load nut or lift nut for Romeico 230 Beissbarth / FOG 444 lift

1x Lifting nut, load nut or lift nut for 2 post lift Romeico 230...

165,41 EUR

incl. 19 % VAT excl. shipping costs

lower bearing insert for MWH Consul 2.25 lift type H049 H052 H105 H109 H142 H155 H165 H167 H169 H 200 H230 H238 H300 H400

1x Bearing insert for lower spindle bearing / Consul 2:25 / 2...

59,56 EUR

incl. 19 % VAT excl. shipping costs

lifting nut complete for autop and Stenhoj Car lift type Maestro/Mascot/Miro 2.25 2.30 2.32 2.35 2.35 2.50

1x original lifting nut, load nut completely new design built...

184,40 EUR

incl. 19 % VAT excl. shipping costs

bearing flange for RAV Ravaglioli lift type KP/KPN/KPX versions / R121 - R123 old version

1x bearing flange for two bearings (without bearings) for...

74,85 EUR

incl. 19 % VAT excl. shipping costs

axial deep groove ball thrust bearing for Hofmann Duolift GS GE GT GT 2500 GTE 2500, ME MSE 5000, MT/MTE 2500 / BT BTE

axial deep groove ball thrust bearing for Hofmann Duolift Type GS...

31,18 EUR

incl. 19 % VAT excl. shipping costs

chain sprocket wheel for Stenhoj Mascot 613 lift

1x chain guide (1/2 inch sprocket down with clamping pin) for...

58,30 EUR

incl. 19 % VAT excl. shipping costs

Original control cable Set 12,45 m for Nussbaum Lift Type SPL 3000 / SPL 3500 / T4 / SPL 4000 / SPL 6000 / SPL 7000 / SPL 8000

1x original cable set (as shown in the picture) control cable...

416,86 EUR

incl. 19 % VAT excl. shipping costs

Support ring, piston seal new design TGL 21551 for 2 tons DDR Takraf Scissor lift Lunzenau Hoists

1x Backup ring hydraulic ram for 2 tons Takraf Lunzenau scissor...

8,99 EUR

incl. 19 % VAT excl. shipping costs

2x bearing Upper spindle bearing (thrust bearing + deep groove ball bearing) Ravaglioli KP/KPN/KPX versions / R 121- 123 old version (bearings for bearing-flange)

2x bearing for bearing flange in Set / upper spindle bearing...

44,48 EUR

incl. 19 % VAT excl. shipping costs

Lifting nut, load nut for MWH Consul lift (old version) Type FH 325 (high quality replica)

1x lift nut, load nut for MWH Consul lift (old version) type FH...

169,30 EUR

incl. 19 % VAT excl. shipping costs

Filu Fuel filter for VEB Takraf Forklifts DFG 3202 N-A DFG 4002 IFA etc.

1x prefilter for DK-stage filter = double filter housing in...

13,09 EUR

incl. 19 % VAT excl. shipping costs

receiving increasing + rubber recording for Zippo lift type H383 2135 - H387 2140 - 17er series (134mm x 17mm with steel insert)

1x original mounting bracket + rubber mount for Zippo and others....

68,43 EUR

incl. 19 % VAT excl. shipping costs

ribbed v-belt for Maha lift type Econ EL 2.5 GF / EL 3.0 GF / 2.5 tons 3 tons Capacity

1x ribbed v-belt, drive belt, toothed flat belt for Maha lift...

33,74 EUR

incl. 19 % VAT excl. shipping costs

Pulse generator long proximity switch speed sensor for Maha Mapower lift / Econ 2 / 3

1x initiator / threshold sensor from the manufacturer Maha...

67,53 EUR

incl. 19 % VAT excl. shipping costs

control cable, safety cable, shift cable for Stenhoj Mascot / Maestro lift

1x switch cable (safety cable, construction cable, safety cable)...

56,41 EUR

incl. 19 % VAT excl. shipping costs

lift pad, rubber pad, rubber plate for Intertech lift (120mm x 20mm)

1x rubber plate for Intertech 2 post lift - Autolift - Platforms...

11,90 EUR

incl. 19 % VAT excl. shipping costs

Master cylinder brake cylinder Takraf forklift VTA DFG 1002 Paul Fröhlich

1x A circular cylinder (cylinder + container + cuff) for VTA...

74,02 EUR

incl. 19 % VAT excl. shipping costs

Our top products

Cookie Consent